PTO Garage

Purge Valve Replacement on a 2008 Mazdaspeed3, I recently was having a hard start after refueling, the car would start and idle at 500 rpm and barely run and would stall but would restart and with a quick gas pedal press it would run fine once it idled out. So I googled a bit and found that it was the purge valve.  I bought one from AMAZON.com  the Dorman 911-702 Mazda 6 Purge Valve Start by removing the Inter-cooler Cover Screws and the plastic guard. Locate the Purge Valve (in between the inter-cooler and the battery box) Remove the hose guarding to get to the clamps and remove the power connector to the purge valve Remove the Hose Clamps and slide off the Purge Valve The rubber mount will not be in the Same Orientation  Remove the Rubber mount from the new one and align to be the same as the one you just removed Re-install in the reverse order and Enjoy your speed again Amazon Affiliate Links used in po...

Changing the idler pulley, serpentine belt and tension pulley on a 2008 MazdaSpeed 3 is quite easy ( I do not know if this all applies to the regular Mazda 3) and can be completed in a couple hours. I got all my parts from Napa www.napaonline.com  / good luck 1. Set the e-brake 2. Loosen the Lug nuts on the Front Passenger Tire 3. Jack the front of the car and support on jack stands 4. Remove the front Passenger tire 5. Remove the bolts that attach the small plastic splash guard toward the front of the fender well ( this gives you a bit more room for getting at the idler)  (A view from the top of the engine bay) 6. Use a Combo Wrench on the Tensioner Pulley to slack the belt and slide it off the pulley (Turn the wrench Clock-Wise to slack the belt, note that there is a notch so that the Tensioner can only rotate so far so do not exert the Tensioner beyond the point it feels it stops rotating) 7. Remove the two bolts that hold t...